7
6.7 Depth adjustment of the sliding leaves
- Use a size 13 wrench to position the moving leaf parallel to the box
profile, then measure the distance between the leaf and the beam or
the wall. Put the 2 ends of the sheet at 5 mm.
6.8 Fitting the Guide
- Move the sliding leaf to find an angle of 90º degrees, to do so use
a spirit level.
- At this point, position the guide on the ground at the end of the
fixed leaf, with the block inserted into the sliding leaf guide, mark
the ground when the blade is level.
- Then secure the guide to the ground and slide the leaf over the
guide.
6.9 Height Adjustment of the Leaves
- Adjust the leaf height using the central screw of the carriage. This regulation is
very important, the leaves must be parallel when they meet.
6.10 Placing the limit switch
- Place a limit switch where the moving blades meet, to do so insert 2 long nuts on the rail and fasten the limit switch
stop with M6x10 Allen screws.
- The other limit is placed on one of the sides.
15.5
27
90
°
Regulation screw
Tope lateral
