17
Operator installation
Check the installation space:
Disassemble the operator's bracket profile
:
10 mm of space from the top of the operator.
The operator's fastening structure must be solid and
must not have significant deformation.
Minimum dist
ance
10mm
260
40
640
245
55
40
71,4
48
36
23
Ø6,5
1
Remove the screws from the cover and extract it.
2
Release the electronic plate's side switch cable and side
reset button cable.
3
Release the geared motor screws (4) and remove the
entire body.
Fasten the bracket to the wall with the side covers,
since level X is referenced on the outside face of
the cover (installation drawings).
36 37 38
14 15
Side
switch
Reset
button
Operator assembly on bracket profile
1
Fasten the geared motor to the bracket profile with the
screws (4).
Firmly secure the four screws of the geared motor.
2
Insert the side switch and side reset button cables in the
control board.
36 37 38
14 15
Side
switch
Reset
button