18
Spring pre-charging and arm installation
1
Open the door. Attach the arm to the shaft in any position.
2
Turn the arm in OPENING DIRECTION and lock the
geared motor with the special locking piece supplied
with the operator.
3
Release the arm. Let the door close. Re-attach the arm to the
shaft in the POSITION WHERE THE END OF THE ARM COMES
INTO CONTACT WITH OR IS VERY CLOSE TO THE DOOR.
4
Turn the arm and remove the locking piece.
5
Attach the arm to the door.
The APR02 arm is mounted in the same way.
See the “Installation Guide” for more details on this
procedure.
Motor brake
Braking direction
: position the electronic plate's switch
(2) so braking is in closing.
Regulating braking force
: force can be regulated by
positioning the electronic plate's jumpers (1) in different
positions.
Remove motor brake
: the cable connector (3) must be
Normally Closed (NC) for the motor brake to work. The
motor brake can be disabled using the operator’s
microswitch, and the door closes with more force. Adjust
the part (4) to enable the microswitch (5).
Test the passive brake:
Operator without power.
Operator running: Manual mode.
32 33 34 35
36 37 38
39
40
MOTOR CONNECTOR
ENCODER CONNECTOR
Pos 2
MED.
BRAKE
Pos 1
MAX.
BRAKE
Pos 3
MIN.
BRAKE
LEVEL - MOTOR BRAKE
MOTOR BRAKE (ON/OFF)
(NC)
DIRECTION - MOTOR BRAKE
(4)
(5)
LED - PROGRAMME RUNNING
LED - ERROR
LED - BOARD POWER SUPPLY
+24 PI3 PI4
+24
CAN
L
CAN
H
Spring force
Do not carry out this operation until the arm is
positioned correctly. Failure to do so may damage the
operator.
Regulate closing force with the door in closed
position and without power.
The spring must be pre-charged in closing
position. Otherwise the spring will be at rest, and
spring adjustment will have no effect on closing.
Adjust spring force as necessary.
To do this, turn the screw (1) clockwise to increase closing
force, or anti-clockwise to reduce closing force.
The door must be easy to open by hand, and the operator
must close it fully (gently and without slamming the door).