i-CON 1 / 8
3BA00180 • 8.04.008 • Rev. 1
Operating instructions
3.2
Intended use
ERSA heating tools may only be used for the processing of soft solder. In special
cases, however, if stated explicitly in the operating manual of the respective tool,
some tools can also be used to work plastics. If the tool is not used as intended or
tampered with, the manufacturer cannot be held liable for any warranty and liability
claims on part of the purchaser.
Attention!
Check all components before use. Have any damaged
parts repaired by a specialist or the manufacturer. Incorrectly per-
formed repairs represent a risk of accidents for the user. Always use
genuine ERSA spare parts for any repairs.
Attention!
Heating tools get hot. Before heating up the device, check
that the tool insert (e.g. soldering tip, modelling insert, etc.) is cor-
rectly connected to the heating tool. Do not allow the hot tool insert to
touch your skin, your hair or any materials which are heat-sensitive
and flammable. Always work on a base with adequate heat-resistant
properties.
Attention!
Restrict unauthorised access. Make sure that no unauthor-
ized person, in particular children, can get near heating tool without
your permission.
Attention!
Danger of fire. Before heating up the heating tool, remove
flammable objects, liquids and gases from the area where you will be
working with your heating tool. Whenever you take a break from your
work, place the heating tool in the holder provided for that purpose.
Disconnect your heating tools from the mains after use.
