7
MOUNTING INSTRUCTIONS
After uncrating the attachment, use the following procedure to mount the Mega Mower to the loader.
1. Use the step, treads, and grab handles to
get on and off the loader and brush mower.
2.
Sitting in the operator’s seat, lower seat bar
and fasten the seat belt.
3. Drive the loader to the rear of the brush
mower. Put the loader quick attach coupler
into the brush mower mounting bracket.
4. Tilt the loader coupler backward a small
amount until it is fully engaged in the brush
mower mounting bracket.
5. Stop the engine and engage the park brake.
6. Secure the coupler locking mechanism that
attaches the brush mower to the loader.
Coupler wedges or pins
must extend through the holes in the
attachment mounting plate. Levers
must be fully down and locked. Failure
to secure wedges or pins can allow
attachment to come off and cause injury
or death.
7. Route the lift limit chain over the boom
cross-member and down through a hole in
the front frame. Then latch the end of the
chain back to itself allowing for some slack.
Make sure the chain will not contact the
rotating blades when mowing in reverse.
Lift limit chain must be
installed to limit the total lift height of
the attachment to less than 12 inches
(300 mm). Failure to install the lift limit
chain
can
increase
the
risk
of
dangerous flying debris being thrown at
the cab causing serious injury or death.
