19
Auger Removal and Installation
1. Loosen the setscrew on the bearing
eccentric locking collar. Using a hammer
and punch, rotate the collar in the opposite
direction of auger travel.
NOTE:
This frees up the bearing and
allows it to slide on the auger shaft.
2. Disconnect the tubelines from the auger
motor.
3. Remove the two bearing retaining bolts and
the four auger motor housing bolts.
NOTE:
Pry
the
bearing
flange
approximately 1/4” to the inside to allow
clearance for the auger to be removed.
___________________ AUGER REMOVAL ____________________
Summary of Contents for 2020 Series
