11
OPERATING INSTRUCTIONS
.
7. Once the attachment has started cutting,
engage the control to start the grinder arm
swinging.
NOTE:
The arm senses the difficulty of the
cut and will automatically adjust the travel
speed.
8. When the attachment has completed a pass,
move the loader rearward about 1-
1/2” and
engage the control to cut back across in the
opposite direction.
9. Continue until a completed layer of the stump
has been ground off and then repeat the
procedure starting again at the front of the
stump.
10. The next cuts will be performed to take the
stump below ground level, if wanted.
When cutting below grade
you may be more likely to throw rocks or
other debris. To avoid injury or death,
never direct discharge toward people.
11. Follow the same procedures as cutting
above ground level, with the addition of
inspecting the area thoroughly for large
rocks/debris
that
may
damage
the
attachment.
Final Cut
1 to 2 inches
Direction of Loader
travel between cuts
Final Cut
NOTE:
Shown after a
series
of 1 to 2 inch deep cuts.
Direction of Loader
travel between cuts