12
_____________________ROUTINE MAINTENANCE________________
Lower the stump grinder to rest on the ground, shut down the engine, relieve the
hydraulic pressure to the attachment, wait for all motion to stop, and set park brake before leaving
the operator’s position to perform service of any kind.
It is the operator’s responsibility to make daily inspections of the loader and attachment for damage, loose
bolts, fluid leaks, or anything else that could cause a potential service or safety problem. Preventive
maintenance is the easiest and least expensive type of maintenance.
IMPORTANT:
Bolts and set screws can loosen after initial usage. After the first hour of operation check all
bolts and set screws.
Use No. 2 lithium base gun grease when
lubricating
all of the attachment’s grease fittings.
Grease the attachment Arm Pivot Bushing zerk
[A]
and the Swing Arm Pivot Bushing
[B]
.
Grease all bushings once after every
8 hours
of
operation.
8
LUBRICATION
[A]
[B]
No. 2 Lithium
base gun grease
