8
Attaching Hydraulics:
1. Connect the hydraulic quick couplers from the
attachment to the loader.
IMPORTANT:
Make sure the quick couplers
are fully engaged. If the quick couplers do
not fully engage, check to see that the
couplers are the same size and brand. Do
not force the quick couplers together.
IMPORTANT:
Wipe the ends of the hydraulic
quick couplers (both lead and loader) with a
rag to remove any possible contamination.
Contamination
can
cause
hydraulic
components to fail and is not covered under
warranty.
2. Connect the attachment wire harness to the
loader wire harness receptacle.
3. Make sure the hoses are properly routed to fit
your specific loader. If the hoses are not
routed correctly, hoses may get pinched or
rub on tires. Be sure to check the hose
routing through the full range of intended
motion of the attachment before operating it.
More than one routing may be acceptable
depending on the loader. Pick the routing
that best suits your loader.
IMPORTANT:
Proper hose routing is the
responsibility of the owner and/or operator.
Pinched or stretched hoses are not covered
under warranty.
Mounting is now complete and you are ready to
use the stump grinder. Use reverse order of
above instructions to dismount the stump grinder
from the loader.
USER
’S INSTRUCTIONS FOR MOUNTING THE MINI STUMP GRINDER
NOTE:
Attachment is shipped with 12FJX (1-
1/16”
Female JIC Swivel) fittings on the ends of the lead
hoses.
