ERTF
User Guide SpeedoCap 3
V 1.22
Page 5 / 13
2.1 Installation
Caution:
Installation
: Guarantee is not applicable if mounting is not correct and/or without using the silent-bloc.
Washing
: Devices must be protected and taken out of water during the wash of vehicles; any problem of
waterproofness due to the lack of protection could not be taken under the commercial guarantee.
3. FUNCTIONNING CONNECTED TO GPS UNIK 2
3.1 Switch on
Speedocap switches on automatically when the GPS is started up.
It goes out when the GPS goes out. The configuration is kept but the MAX SPEED value resets to 0 and in
off-line mode the ODO value resets to 0.
From 1.11 version, at switch on, Speedocap displays the last screen shows before the switch off (if it was
displayed 30 seconds at least).
3.2 Configuration
To reach the configuration screen, it is necessary to press on 2 buttons at the same time.
You browse in the configuration screens using the high and low keys (+ and-) the selection of one under
menu or a parameter is made by pressing on 2 keys at the same time.
3.2.1 Backlight
ON = 1 : To set the backlight from 0 to 100%.
OFF = 0 : Automatic mode.
3.2.2 Info Waypoint
When the compass is visible on the GPS, it is automatically displayed on the Speedocap.
When the compass is not visible on the GPS, there are 3 possibilities:
a) Info Wpt= 0, nothing displayed
b) Info Wpt= 1, name of the target Waypoint is displayed
c) Info Wpt= 2, name and number of the target Waypoint are displayed
3.2.3 Automatic Backlight
To appropriate the backlight to the outside luminosity. Work on Day/Night mode: when it is the night
luminosity is minimal.
3.2.4 Enable remote (from 1.11 version)
To activate or deactivate the navigation in the Speedocap screens via the GPS remote control.
3.2.5 Output
To activate the output for the external lamp.
3.2.6 Odometer
To set to 1 or 2 the decimals number of the odometer counter.
For the Speedocap Evo, you can also set an adjustment odo from -99m by kilometre to +99m by kilometre.
By default it is 0.
From 1.10 version, the parameter “Display Odo Type” allows to choose between the display of Odo Total (0)
or Partial (1).
3.2.7 GPS Status
To check the satellite reception.
