Pr
o
-
C
Series
7
12. Secure the right side angle trim to the PRO-C unit
with the screws provided.
10. Bring the units together and set into place.
14. If included, place the pedestal support at end of the
PRO-C unit, opposite the Carrier Unit. The pedestal
support is adjustable from 9” to 14”.
15. Install the Outside Air and Exhaust Air hoods on the
PRO-C unit.
11. Install the left side angle trim to the Carrier unit and
PRO-C unit and secure with screws.
13. Lower the roof of the carrier unit so that it covers the
top edge of the PRO-C unit. Secure with screws and
caulk.
NOTE: Rooftop unit fi lter access will be through the
return air access panel (See Figure 5a.)
9. Install the gasket to the left and right facing edges of
the Carrier unit.
The PRO-C unit is designed to support off the end of the
Carrier unit. A required optional pedestal support is avail-
able from ERV Systems for the PRO-C series. The PRO-C
series should not be installed without the pedestal support.
(See Figure 5a.) This pedestal adjusts in height from 9 to
14 inches.
Support
To install the pedestal support, position the PRO-C
on the Carrier unit. Locate the pedestal under the front of
the PRO-C unit as shown. Lock the pedestal to the correct
height with #12 TEK screws. Fasten the top of the pedestal
to the base of the PRO-C with a minimum of 4 #12 TEK
screws. (See Figure 5b.)
Figure 5a. Installation of the pedestal support is on the front
side of the PRO-C unit.
Figure 5b. Side view of the finished installation is shown.
2ETURN
!IR
!CCESS
0ANEL
#!22)%25.)4
02/#3%2)%3