- 18 -
EN
1C29
CHANNEL SET UP
Make sure ...
•
Press the POWER button to turn on the unit.
1
Select “CHANNEL SET UP”
Press the SETUP button on the
remote control.
Press the Arrow button
K
or
L
to
point to “CHANNEL SET UP”.
Then press the ENTER button.
2
Begin auto ch programming
Press the Arrow button
K
or
L
to
point to “AUTO CH PROGRAM-
MING”.
Then press the ENTER button.
The tuner scans and memorizes all
the active channels in your area.
3
After scanning
The tuner stops on the lowest memorized channel.
•
When AUTO CH PROGRAMMING is activated
where there is no TV signal input, “NO TV SIG-
NALS” will appear on the display after the com-
pletion of the channel scanning.
•
The unit may recognize TV channels to be CATV
channels by the receiving conditions. In this case,
try auto ch programming again after checking
antenna connection.
- TV/VCR SETUP -
TIMER PROGRAMMING
SETTING CLOCK
B
CHANNEL SET UP
USER’S SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
ZERO RETURN
TIME SEARCH
INDEX SEARCH
– CHANNEL SET UP –
ADD / DELETE CH (CATV)
B
AUTO CH PROGRAMMING
The channels you no longer receive or seldom watch
can be deleted from the memory. (Of course, you
can add the deleted channel into the memory again.)
1
Select “CHANNEL SET UP”
Press the SETUP button on the
remote control.
Press the Arrow button
K
or
L
to
point to “CHANNEL SET UP”.
Then press the ENTER button.
2
Select “ADD/DELETE CH”
Press the Arrow button
K
or
L
to
point to “ADD/DELETE CH”.
Press the ENTER button.
3
Enter the desired channel number
Press the Arrow button
K
or
L
until your desired channel number
appears. (You can also use the
number buttons or the CHANNEL
button
K
or
L
to enter it)
(Example: CH8)
•
You must precede single-digit channel numbers
with a zero (Example: 02 ... 09).
•
When selecting cable channels which are higher
than 99, press the +100 button first, then press the
last two digits. (Example: to select channel 125,
first press the +100 button then press “2” and “5”).
4
Delete (or add) it from (or into) memory
Press the ENTER button. The channel number
changes to light red. The channel is deleted from
memory.
•
To delete another channel, repeat steps [3] to [4].
•
If you press the ENTER button again, the channel
is memorized again.
5
Exit the channel setup mode
Press the SETUP button on the remote control to
return to TV mode.
NOTE:
To confirm that channel(s) has been deleted
or added, press the CHANNEL button
K
or
L
.
DELETING (OR ADDING)
CHANNEL(S)
Added channel: Light blue.
Deleted channel: Light red.
- TV/VCR SETUP -
TIMER PROGRAMMING
SETTING CLOCK
B
CHANNEL SET UP
USER’S SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
ZERO RETURN
TIME SEARCH
INDEX SEARCH
– CHANNEL SET UP –
B
ADD / DELETE CH (CATV)
AUTO CH PROGRAMMING
08
ADD / DELETE
You can program the tuner to scan all the channels
you receive in your area.
NOTE:
Channel memory programming is NOT
needed when connected to a cable box or satellite
box. Just select the TV/VCR/DVD channel selector
to the output channel of the cable box or satellite box
(Ex CH3), then select the channel to be viewed on
the Cable Box or Satellite Box.
TV/VCR
TV/VCR
