ESAB LKA 180, Instruction Manual

−

 8 

−

bc05d18e

6.1

Spot welding

Select the spot welding time  (G) on the scale marked 1

−

10. Spot welding

time can be set anywhere between 0.2

−

2.5 sek.

To set the welding voltage and wire feed speed see the recommended
table on page 9. 
Press the torch trigger. When the set welding time has elapsed welding
will stop automatically. There is no need to release the trigger. 
A new welding cycle will start when you press the trigger again. 

bc09

7

MAINTENANCE

Note:
All warranty undertakings given by the supplier cease to apply if the customer
attempts to rectify any faults on the machine during the warranty period.

IMPORTANT

This welding equipment has been designed, tested and manufactured to give long,

trouble

−

free service. 

Regular maintenance is essential for safe and reliable operation.

Removal of dust 

Blow away dust that has gathered in the power source 

using dry compressed air at low pressure.  

Wire feed unit

Components that are subject to wear must be 

regularly cleaned and replaced to ensure reliable 

wire feed. Note that if the tension is too high it may 

cause excessive wear on the pressure roller, 

feed roller and wire liner. 

Torch

Regularly blow the wire liner clean and clean the gas shroud

8

ORDERING OF SPARE PARTS

Spare parts are ordered through your nearest ESAB representative, see back cover.

When ordering spare parts, please state machine type and number as well as desig-

nation and spare part number as shown in the spare parts list.

This will simplify dispatch and ensure you get the right part.

GB

455 894

−

001

367 556

−

001

466 074

−

001