4 INSTALLATION
0349 301 124
- 9 -
© ESAB AB 2017
4
INSTALLATION
The installation must be carried out by a professional.
CAUTION!
This product is intended for industrial use. In a domestic environment this product
may cause radio interference. It is the user's responsibility to take adequate
precautions.
WARNING!
Straps must be used when lifting the
power source. The handle is only
intended for pulling it.
4.1
Positioning of welding power source
Position the welding power source in such a way that its cooling air inlets and outlets are not
obstructed.
4.2
Assembly of counter balance
Assemble the stab CB KIT if the counter balance is to be installed on the power
source. The stab CB KIT is an accessory. See "ACCESORIES" chapter for order
number.
NOTE!
Use of a counter balance without stabilizer may cause the welding equipment to
tip over.
Summary of Contents for Origo Mig L305
