© ESAB AB 2011
- 8 -
bp16ea
WARNING
Do NOT start the equipment with the cover removed.
Do NOT connect the equipment under tension or when you are holding it or
carrying it.
Do NOT touch any of the torch's parts when the power supply is on.
CAUTION
This product is intended for industrial use. In a domestic environment this product may
cause radio interference. It is the user's responsibility to take adequate precautions.
CAUTION
Place the power source at least 3 metres from the cutting area as sparks and slag spray
can damage the power source
4.1
Delivery check and location
1.
Remove the packaging. Inspect the equipment for damage that was not
immediately apparent upon reception of the delivery. Immediately report any
damage to the delivery company.
2.
Check for any loose parts in the packaging. Check that the air ducts in the
cover's rear panel are not blocked with packaging material that can prevent the
air flow through the power source.
The power source has a lifting eyelet and can be lifted easily. Check that the
lifting equipment that is to be used can withstand the weight of the power source.
The weight is stated in the table TECHNICAL DATA, see chapter
3
.
WARNING
The product must be lifted as follows:
3.
Position the power source so that its cooling air inlets and outlets are not
obstructed. Minimum permitted distance to wall or other obstruction is 30 cm.
4.
An air source that gives clean and dry air, at least 236 l/m at 6.2 bar (90 psig), is
required for cutting. The cutting air pressure must not exceed 10.3 bar
(150 psig), which is the maximum inlet pressure for the filter regulator that is
included in the delivery.
GB