-- 62 --
bu12d04a
The following weld parameters are adjustable:
S
for
MIG
S
Wire feed speed
and
S
Voltage
S
for
STICK
S
Welding current
S
for
TIG
S
Welding current
S
for
Arc air gouging
S
Voltage
Limits for parameter adjustment are set in the following way.
A plus value (upper limit) and a minus value (lower limit) are given for each
parameter, where the reference is made up of the weld data set--up’s original setting.
GENERAL DEFAULTS -- FASTMODE
Position the cursor
on the line for the
current weld
parameter.
e.g. VOLTAGE.
SOFT KEY NUMBER:
1
VOLTAGE:
#
+ 0.0 V
*
-- 0.0 V
WIRE SPEED:
#
+ 0.0 in/min
*
-- 0.0 in/min
ASSOCIATED WELD DATA:
16
DIP/SPRAY. Fe, CO2,
0.045”...
QUIT
Use the plus/minus buttons to indicate the desired value for the upper and lower
limits.
9.2.8.2 Double start signals
CONFIGURATION -- GENERAL DEFAULTS
FAST MODE LIMITS
DOUBLE START SOURCES
OFF
TRIGGER WELD DATA SWITCH
QUIT
ENTER
With this alternative, the MIG wire feed unit can be started from the TIG card
(universal).
It also enables start of the TIG torch from the wire feed unit.
This function can be useful in mechanized applications.
