Copyright 2004 by Election Systems & Software, Inc. Model 100 Pre-Election Day Checklist
All rights reserved.
10
74.
75.
Adjust the date or time, by pressing the
SELECT
button to move through
the number positions and press
PLUS
or
MINUS
to increase or decrease
the values.
Press
PREVIOUS
when you have set the correct date and/or time.
Locking Out the System Settings
Press
PREVIOUS MENU
twice to return to the
DIAGNOSTIC TEST
menu. The message,
“LOCK OUT SYSTEM SETTINGS?”
appears.
76.
77.
CAUTION!
Only press
“YES”
if you wish to Lock the system settings
for your election. These settings cannot be changed unless a new
PCMCIA card is loaded into the scanner.
You will probably want to
select “NO” during all testing and training phases of preparing for
the election.
Checking the Status of the Wireless CDPD Modem
WARNING: Do not perform these steps if you do not have the
CDPD modem. The scanner will lock up if you perform Steps 78-
81 without a wireless CDPD modem installed. If you lock up the
scanner, turn it off and on again.
NOTE: Steps 78-81 are necessary only if your Model 100 is
equipped with a wireless CDPD modem and you are using that
capability in the election.
Press
PREVIOUS
until the message,
“ELECTION CARD
INSERTED, OPEN POLLS NOW?”
appears.
78.
79.
80.
81.
Press the first and second buttons from the left at the same time to open
the
MODEM
menu.
Press
MODEM SETTINGS
to change phone numbers, set up the
CDPD modem, and to configure other modem functions.
Press
CDPD STATUS
to verify the status of the modem itself.
