Copyright 2004 by Election Systems & Software, Inc. Model 100 Pre-Election Day Checklist
All rights reserved.
5
40.
41.
42.
43.
Thread the cord through the opening on the back of the ballot box
until it appears through the slot at the back of the top recessed
area.
Pull the cord until it extends a few inches into the recessed
opening.
Unlock and open the Counter Access panel. Place the scanner
about 1/3 of the way into the recessed area and slide it on the
mounting rails until it is four to five inches from the back of the
recessed area.
Plug the female end of the power cord into the Power Entry
Module on the back of the scanner.
WARNING: Only plug the scanner into a grounded, three-
pronged electrical outlet. Plug only one scanner into an
outlet. ES&S recommends that you do not use an extension
cord.
44.
45.
46.
Lift the metal tab which covers the ballot box’s ballot entrance
slot (located in the back of the box’s recessed area and marked
with “LIFT TO OPERATE”) so that that the slot is exposed.
Slide the scanner until it is against the back of the ballot box
ensuring that the diverter connector at the back of the scanner
slides into its mate on the ballot box. Leave the Counter Access
Panel (located on the front of the scanner) in the down
position.
Plug the male end of the cord into a wall outlet. NOTE: If the
cord is plugged in incorrectly, the message, “NO-AC” will
appear when you turn on the scanner.
