User Manual
10
Installation Cont.
Electrical connection
•
WARNING
It must be possible to disconnect the appliance from the mains power supply; the
plug must therefore be easily accessible after installation.
• Before plugging in your fridge, let it stand upright for at least 2 hours. This will allow the refrigerant
gases to settle into the compressor and reduce the possibility of a malfunction in the cooling system.
• The appliance must be earthed. The plug of the power supply cord is equipped with a contact for this purpose.
Do not under any circumstances cut or remove the third (earth) prong from the power cord. If the plug does not
fit your outlet, consult a licensed electrician for advice to have the outlet changed.
• Plug the unit into a dedicated, properly earthed wall outlet. Ensure that your outlet voltage and circuit
frequency correspond to the voltage stated on the rating label.
• Secure the fridge’s supply cord behind the unit. Do not leave it exposed or dangling to prevent injury
and accidental disconnection from the power supply.
• When first starting up, and after a period out of use, allow the unit to cool down for at least 2–3 hours
(4 hours if starting up during warm weather in summer) before placing food in the fridge.
Levelling the Fridge
Precautions before levelling the fridge:
• Ensure that the fridge is disconnected from
the power source
• Make precautions to prevent any personal injury.
Adjusting procedures:
a. Turn the feet clockwise to raise the refrigerator;
b. Turn the feet counterclockwise to lower the refrigerator;
c. Adjust both feet so the refrigerator is level.
Installation (Continued)
Raise
Lower
Note:
The images and diagrams in this user manual are for reference only. Your appliance may appear differently.
