esatto.house
13
Installation Instructions
INSTALLATION PROCEDURE
• Do not modify this appliance.
•
WARNING:
This appliance must be installed
by an authorised technician or installer.
• Prior to installation, ensure that the local distribution conditions (nature of the gas and
gas pressure) and the adjustment of the appliance are compatible.
• The adjustment conditions for this appliance are stated on the label (or data plate)
• This appliance is not connected to a combustion products evacuation device. It
should be installed and connected in accordance with current installation regulations.
Particular attention should be given to the relevant requirements regarding ventilation.
• Before installing, turn off the gas and electricity supply to the appliance.
• All appliances containing any electrical components must be earthed.
• Ensure that the gas pipe and electrical cable are installed in such a way that they do not
touch any parts of the appliance which may become hot.
• Gas pipe or connector shouldn’t be bent or blocked by any other appliances.
• Check the dimensions of the appliance as well as the dimensions of the gap to be cut in
the kitchen unit.
• The panels located above the work surface, directly next to the appliance, must be made
of non-flammable material. Both the stratified surfacing and the glue used to secure it
should be heat resistant, to prevent deterioration.
• Turn on appliance tap and light each burner. Check for a clear blue flame without yellow
tipping and if burners show any abnormalities check the following;
– Burner lid is on correctly
– Flame spreader is positioned correctly
– Burner vertically aligned with injector end
• A full operational test and test for possible leakages must be carried out by the installer
after installation.
• The flexible hose shall be fitted in such a way that it cannot come into contact with a
movable part of the housing unit and does not pass through any space susceptible of
becoming congested.
• Grease cranes produced at the factory to meet the requirement of all life hob.
CAUTION:
Cooktops are supplied set up for natural gas (NG). To use on LPG, the injectors
must be changed using the conversion kit supplied. Refer LPG Conversion on page 19.
Figure 5 – ECG604E
600
510
490
95
560
Gas
Supp
ly
Conn
ectio
n
200
60
200
