User Manual
08
USER MANUAL
PAGE 08
INSTALLATION INSTRUCTIONS
LOCATING THE FI ING BRACKETS
The unit should be placed on a stable, smooth surface (use the packaging). Do not apply force onto the controls
protruding from the hob.
Fix the hob on the work surface by screw four brackets on the bottom of hob (see picture) after installation.
Adjust the bracket position to suit for different work surface’s thickness.
The ceramic cooker hob must be installed by qualified personnel or technicians. We have professionals at
your service. Please never conduct the operation by yourself.
The ceramic cooker hob shall not be mounted to cooling equipment, dishwashers and rotary dryers.
The ceramic cooker hob shall be installed such that better heat radiation can be ensured to enhance its
reliability.
The wall and induced heating zone above the work surface shall withstand heat.
To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
A steam cleaner is not to be used.
This ceramic can be connected only to a supply with system impedance no more than 0.427 ohm. In case
necessary, please consult your supply authority for system impedance information.
►
►
►
►
►
►
►
CAUTIONS!
x
PAGE 09
The power supply should be connected in compliance with the relevant standard, or a single-pole circuit
breaker. The method of connection is shown below.
CONNECTING THE HOB TO THE MAINS POWER SUPPLY
►
If the cable is damaged or needs replacing, this should be done by an after-sales technician using
the proper tools, so as to avoid any accidents.
If the appliance is being connected directly to the mains supply, an omnipolar circuit breaker must
be installed with a minimum gap of 3mm between the contacts.
The installer must ensure that the correct electrical connection has been made and that it complies
with safety regulations.
The cable must not be bent or compressed.
The cable must be checked regularly and only replaced by a properly qualified person.
►
►
►
►
►
DISPOSAL: Do not
dispose this product
as unsorted municipal
waste. Collection of
such waste separately
for special treatment is
necessary.
This appliance is labeled in compliance with European directive
2002/96/EC for Waste Electrical and Electronic Equipment (WEEE).
By ensuring that this appliance is disposed of correctly, you will help
prevent any possible damage to the environment and to human
health, which might otherwise be caused if it were disposed of in the
wrong way.
The symbol on the product indicates that it may not be treated as
normal household waste. It should be taken to a collection point for
the recycling of electrical and electronic goods.
This appliance requires specialist waste disposal. For further
information regarding the treatment, recover and recycling of this
product please contact your local council, your household waste
disposal service, or the shop where you purchased it.
For more detailed information about treatment, recovery and
recycling of this product, please contact your local city office, your
household waste disposal service or the shop where you purchased
the product.
