ESB Tanning Systems
Assembling Pedestal
Avalon
and
Grande Models
The pedestal is designed to cover the underside area and legs of the tanning bed. The
pedestal comes in three pieces (2 sides, 1 front), with Velcro affixed to the sides. Begin
by placing the smaller sections (sides) of the pedestal next to the legs with the Velcro
towards the front. Remove the Velcro film. Place the front pedestal over the fronts of
the pedestal sides and affix to the Velcro.
Making the Electrical Connections
–
see electrical requirements.
(Refer to table of contents.)
WARNING! Be sure electrical power is disconnected before connecting the
canopy to bench cables.
Step 1.
Connect the canopy to the bench power cord located on the back of the unit.
Step 2.
Plug the three-prong 120V AC power cord into a 20 Amp dedicated
outlet. Beds with 16 lamps or less require a 15 Amp Dedicated outlet.
NOTE: IT IS BEST TO UNPLUG THE TANNING BED WHILE
NOT IN USE. DO NOT CONVERT THE POWER CORD TO A TWO
PRONG CORD OR USE ANY EXTENSION CORD.
AS RECOMMENDED FOR ALL ELECTRICAL APPLIANCES,
THIS TANNING BED SHOULD NEVER BE OPERATED OUTSIDE
AND NEAR WATER OR WHILE YOU ARE WET.
Pre-Tanning Guidelines
This tanning bed is designed for indoor use and one person at a time, not weighing more
than 300 lbs.
Your Skin
Before tanning, be sure your skin is free of any tanning oils or lotions (except those
approved for indoor tanning use), body lotions or cosmetics. Cosmetics or medications
applied to your skin may increase your sensitivity to ultraviolet light. If you are taking
any medication, or if you are especially sensitive to sunlight, we recommend that you
consult a physician before using this or any tanning equipment. It is also recommended
that you not bathe immediately before using this tanning bed as it removes natural body
oils which protect your skin.
Your Eyes
21CFR1040.20
approved eye goggles are provided with this tanning bed and must be
worn whenever the tanning bed is operating.
Regular sunglasses do not adequately
protect your eyes from ultraviolet light.
Eye
wear
that
is
21CFR1040.20 approved
should be worn while
tanning and by everyone in the room while the tanning bed is in
operation.
