Step 3.
Standing in front of the bed, grasp the long exposed edge of the wire grill and
carefully slide it toward you until it is removed.
Canopy ( Optional Grid ) Re-installation
Step 1.
Place grill back onto bed.
Step 2.
Take one end of the black acrylic trim and press firmly onto the aluminum
frame pushing into the opening. The longer flat edge of the trim must be
against the top of the grill.
Step 3.
Place the palm of your hand on the trim, and apply pressure along the edge until
the trim is firmly in place.
Lamp Removal & Re-installation
ESB Lamps are rated up to 1000 hours of use. You may elect to change lamps sooner.
Step 1.
After removing acrylics or grid, grasp a lamp at one end and at middle. Turn
the lamp a quarter turn. The lamp may then be gently removed from its holder.
Step 2.
Hold lamp with brand name label facing toward the acrylic and to the left side
of the bed. To install the lamp, insert the pins located on the ends of the lamp
into the slots on top of the lamp holder and turn the lamp a quarter turn to hold
in place.
For lamp replacement, refer to “Lamp Cleaning” section to follow. Lamps used longer
than 1000 hours have lost their tanning power even though they will continue to light.
Only t
he following lamp
s
may be
use
d
in ESB tanning beds:
2268
Sunergy Select (PN 533000)
2274
Sunergy Facial (PN 533001)
2275
Sunergy Duo (PN 533002)
2269
Sun Express (PN 533211)
2271
Sun Express Facial Swirl (PN 53321
2
)
2272
Sun Express Duo Swirl (PN 533210)
2718 Apollo 6.0
1704 Sun Fusion
Dual
FT
You may purchase ESB tanning lamps ESBtans.com or an ESB Authorized Dealer.
Do not use lamps other than those specified
on sunbed label
.
Lamp Cleaning & Replacement
Depending on the amount of usage, it is recommended that you clean your lamps every
six months. To remove the acrylic and/or grill, see Table of Contents. After all the
lamps have been removed, use a soft cloth and a non-abrasive cleaner to wipe down the
aluminum reflectors. Take care not to scratch them because scratched or damaged
reflectors will reduce the tanning capability of the tanning unit. Gently wipe the entire
length of the lamp with a damp cloth to remove any film buildup. Vacuum reflector area
using a soft brush attachment.
ESB Tanning Systems
Refer to label on Sun Bed.
