ESCALADE Mizerak P0900, Assembly Instruction Manual

20

BOTTOM VIEW

OF TABLE

SIDE APRON

BEAM

SUPPORTS

5.

  Determine which side of your pool table you want to attach your 

Accessory Drawer. 

5

Figure

6.

  Determine where the middle of the table is and mark a centerline on the 

inside of the 

first Beam Support

.  Measure 17.5” to either side from 

the centerline and 3/8” in from inner face of Support Beam and mark 

first

 hole location.  Measure 35” from the first hole location and mark 

the second hole location as shown in 

Figure 5

.   

7.

  Mark the third hole location to the 

center 

of the 

Second 

Support Beam 

exactly straight across from the first hole Mark. Repeat for fourth hole 

location but with Second hole mark.   See 

Figure 5

.   

8.

  Using your Mounting Frame double check that the makings for the pilot 

holes line up before drilling.  Hole markings must be centered and 

square to other hole markings for proper drawer alignment.

Using a 

7/64” bit

, drill pilot holes about 

1” deep

 into the Beam supports,

keep 

Drill straight when drilling so pilot hole is as straight as possible.

Mounting

frame 

assembly

Match these holes up with the 

hole mark on the Support Beams 

before drilling any holes.

This face should be flush 

against the inner part of 

the first Support Beam.

35”

Center line

Mark the Center 

line on the inside 

of the 

first Beam

Mark 

second 

hole location

Mark 

first 

hole location

3/8”

first 

hole location 

mark should line 

up with this hole

Second 

hole 

location mark should 

line up with this hole

Mark 

third 

hole location

Mark 

fourth

hole location

Third 

hole location 

should line up with any 

of these slots

Fourth 

hole location 

should line up with any 

of these slots

Second Beam

Center line