7
EScale Grob G103C - Instruction Manual
13. Using a servo tester or receiver, check for
smooth operation of the spoilers. You may
have to adjust slightly to ensure the spoiler
operates smoothly.
The picture opposite shows a small section
being removed from the end of the spoiler
blade..
14. The spoiler is retained in the wing by two
small cross head screws.
15. Check the plastic cap strip for fi t then glue in
place using fl exible CA or epoxy.
Rough up the underside of the cap strip with
coarse sandpaper or a fi le to aid adhesion.
Be careful not get glue around the edges of
the cap strip or in the spoiler mechanism.
16. Your completed spoiler should now sit fl at
with the wing surface.
Repeat steps 9-15 for the other wing.
We recommend you run a separate BEC or
receiver battery if you fi t the optional spoilers
as the current drain when operating the
spoilers may exceed the built in BEC of many
electronic speed controllers.
