4
EScale Samurai - Instruction Manual
1.
Locate the servo holes in the wings and
carefully remove the fi lm covering using a
new blade in your hobby knife.
2.
Depending on which servos you choose to
use, there are several mounting methods. For
inspiration, two mounting methods are shown
the end result is the same, so use one of
these or another method if you choose.
If you are using micro servos with horizontal
mounts, locate the small plywood servo
mounts and trial fi t your servo in the hole.
Adjust if necessary
Connect the servo to a servo programmer or
receiver to set for neutral position.
3.
This is the result you are looking for with a
micro servo.
4.
If you are using a purpose built wing servo
you will have to enlarge the hole in the wing
to accept the servo.
Trial fi t your servo in the hole.
FITTING AILERON SERVOS TO WINGS
