5
EScale Samurai - Instruction Manual
5.
Use a felt tip pen to mark around the servo.
6.
Use a sharp hobby knife to remove the fi lm,
balsa and foam to allow the servo fi t neatly in
the hole..
Attach a 300mm servo extension lead to servo
and use the cord provided or wire with a hook
to pull the servo lead through the wing.
7.
Use the plywood servo mounts provided or
if they are not suitable, make a mount from
5mm ply as shown.
Glue the servo frame into position using foam
safe CA or epoxy.
8.
Screw the servo into the frame.
Install the control horn, pushrod and retainer.
TIP: Remember to add the retainer prior to putting
the right angle bend at the horn end.
