Issue Date: 23 May 2011
Version 1.1
Escort iMiniPlus PDF Logger
Quick
User Guide v1.1
Escort Verification Technologies, Inc.
dba
ESCORT Data Loggers
PO Box 309, 120 Parkway Drive
Buchanan, VA 24066
Ph: 540-254-1433 Fax: 540-254-2433
- 10 -
Email:
techsupport@escortdataloggers.com
Page1 of PDF report
Header: Each header displays logger serial number and date /
time information from logger without time zone and daylight saving
Device Specification
•Product Code
•Serial Number of the logger
•Hardware version – this is actually
firmware version
•Description string programmed to the
logger by Escort Console
•Battery status last measured by the
logger before it has been connected to PC
•Time Zone and daylight savings
programmed to the logger
•Date / Time when logging trip started
•Date / Time when logging trip finished
•Current number of readings and total
duration of the trip
•Logger temperature range
•Alarm limits programmed to the logger
Statistics part includes:
•Highest temperature reading for the current trip
•Average temperature reading for the current trip.
Please note:
if the logger is configured for continuous logging, logger
memory is getting overwritten and logger only holds the last 8048
readings. Logger computes average that includes all readings even the
ones already overwritten. Escort Console computes average based on
readings retrieved from logger memory and result may be different.
•Lowest temperature reading for the current trip
•High Alarm status
•Low Alarm status
•Both High and Low Alarm can have the following status:
Disabled – Alarm was not enabled when logger was
programmed
Activated – Alarm has been programmed and triggered
Not activated – Alarm was programmed but has not been
triggered
This part of the report is a graph of readings for the current trip.
This part of the report can be disabled when programming.
You can change date display format to display month first by programming
logger.
Date and Time is displayed along the X axis.
Temperature values are displayed up the Y axis.
If Alarms are disabled Alarm limits are not displayed on the graph