TB-5545 Page 4 of 4
Revision May 2009
© 2009 DESCO INDUSTRIES INC.
Employee Owned
ESD Systems.com • 432 Northboro Road Central • Marlboro, MA 01752 • (508) 485-7390 • Fax (508) 480-0257 • Website:
Figure 4. Using the Multi-Mount Continuous Monitor
Note:
Work surface must have a conductive layer such
as Dual Layer Rubber or Dissipative 3-Layer Vinyl or
Micastat® Dissipative Laminate with conductive buried
layers. Desco Continuous Monitors are not recommend-
ed for use with homogeneous matting.
Maintenance and Calibration
The Ground Gard 3 Plus is solid state and designed to
be maintenance free. The
to NIST traceable standards. There are no user ad-
justments neccesary. Because of the wave distortion
sensing nature of the test circuit, special equipment is
required for calibration. We recommend that calibra-
tion be performed using the SPI
Monitor Calibration Unit. The Calibration Unit is a most
important product which allows the customer to perform
NIST traceable calibration on continuous monitors. The
is designed to be used on the shop fl oor at the
workstation, virtually eliminating downtime, verifying that
the continuous monitor is operating within tolerances.
Per ANSI/ESD S20.20 Paragraph 6.2.2.2 Personnel
Grounding Guidance, “Personnel should check constant
monitoring devices (when used) to ensure that they
are functional and operating before ESDS products are
handled. In addition, constant monitoring devices should
be functionally checked periodically to ensure that they
are operating as designed.”
Limited Warranty
ESD Systems.com expressly warrants that for a period of one (1)
year from the date of purchase, SPI Continuous Monitors will be
free of defects in material (parts) and workmanship (labor). Within
the warranty period, the product will be tested, repaired, or
replaced at our option, free of charge. Call our Customer Service
Department at 508-485-7390 for a Return Material Authorization
(RMA) and proper shipping instructions and address. Include a
copy of your original packing slip, invoice, or other proof of
purchase date. Any unit under warranty should be shipped
prepaid to the ESD Systems.com factory. Warranty repairs will
take approximately two weeks.
If your unit is out of warranty, call Customer Service at 508-485-
7390 for a Return Material Authorization (RMA) and proper
shipping instructions and address. ESD Systems.com will quote
repair charges necessary to bring your unit up to factory
standards.
Warranty Exclusions
THE FOREGOING EXPRESS WARRANTY IS MADE IN LIEU
OF ALL OTHER PRODUCT WARRANTIES, EXPRESSED AND
IMPLIED, INCLUDING MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE WHICH ARE SPECIFICALLY
DISCLAIMED. The express warranty will not apply to defects or
damage due to accidents, neglect, misuse, alterations, operator
error, or failure to properly maintain, clean or repair products.
Limit of Liability
In no event will ESD Systems.com or any seller be responsible or
liable for any injury, loss or damage, direct or consequential,
arising out of the use of or the inability to use the product. Before
using, users shall determine the suitability of the product for their
intended use, and users assume all risk and liability whatsoever in
connection therewith.
