Safety Instructions
!
When working with CAN-PCI/200 follow the instructions below and read the manual carefully to protect yourself from
injury and the CAN-PCI/200 from damage.
!
The device is a built-in component. It is essential to ensure that the device is mounted in a way that cannot lead to
endangering or injury of persons or damage to objects.
!
The device has to be securely installed in the control cabinet before commissioning.
!
Protect the CAN-PCI/200 from dust, moisture and steam.
!
Protect the CAN-PCI/200 from shocks and vibrations.
!
The CAN-PCI/200 may become warm during normal use. Always allow adequate ventilation around the CAN-PCI/200
and use care when handling.
!
Do not operate the CAN-PCI/200 adjacent to heat sources and do not expose it to unnecessary thermal radiation.
Ensure an ambient temperature as specified in the technical data.
!
Do not use damaged or defective cables to connect the CAN-PCI/200 and follow the CAN wiring hints in chapter:
"Correctly Wiring Electrically Isolated CAN Networks".
!
In case of damages to the device, which might affect safety, appropriate and immediate measures must be taken, that
exclude an endangerment of persons and objects.
!
Current circuits which are connected to the device have to be sufficiently protected against hazardous voltage (SELV
according to EN 60950-1).
!
The CAN-PCI/200 may only be driven by power supply current circuits, that are contact protected.
A power supply, that provides a safety extra-low voltage (SELV or PELV) according to EN 60950-1, complies with this
conditions.
Attention !
Electrostatic discharges may cause damage to electronic components.
To avoid this, please perform the steps described on page 8
before
you touch the CAN-PCI/200,
in order to discharge the static electricity from your body.
Qualified Personal
This documentation is directed exclusively towards personal qualified in control and automation engineering.
The installation and commissioning of the product may only be carried out by qualified personal, which is
authorized to put devices, systems and electric circuits into operation according to the applicable national
standards of safety engineering.
Conformity
The CAN-PCI/200 is an industrial product and meets the demands of the EU regulations and EMC standards
printed in the conformity declaration at the end of this manual for the use in industrial environment.
Intended Use
The intended use of the CAN-PCI/200 is the operation as a PCI-CAN interface.
The guarantee given by esd does not cover damages which result from improper use, usage not in
accordance with regulations or disregard of safety instructions and warnings.
!
The CAN-PCI/200 is intended for installation in PCI systems only.
!
The operation of the CAN-PCI/200 in hazardous areas, or areas exposed to potentially explosive
materials is not permitted.
!
The operation of the CAN-PCI/200 for medical purposes is prohibited.
Service Note
The CAN-PCI/200 does not contain any parts that require maintenance by the user. The CAN-PCI/200 does
not require any manual configuration of the hardware.
Disposal
Devices which have become defective in the long run have to be disposed in an appropriate way or have to
be returned to the manufacturer for proper disposal. Please, make a contribution to environmental protection.
Page 4 of 23
Hardware Manual • Doc. No.: C.2021.21 / Rev. 1.1
CAN-PCI/200
