Parameter Display and Configuration via
CICT
CAN-CBM-DP
Software Manual Rev. 2.0
72
Wakeup Time
By means of this parameter a delay is specified in milliseconds which
determines the time a module waits after a RESET or power-on before it
transmits data to the CAN bus.
In default setting of the parameters the wake-up time is 2000 ms.
Wake-up Time
can here only be entered as a decimal value.
Parameter
Value range
[ms]
Descriptions
Wake-up Time
0...32767
Delay in milliseconds.
Decimal value range: 0 ms ... 32767
Table 7.2.2:
Function of parameter
Wake-up Time
Attention:
Wakeup Time
can be set in two different ways:
1. As described above.
2. Via the parameter telegram in the DP properties windows (refer to
page 23)
Both entries are equal. That means that the last specification is valid!