All rights reserved. Reproduction as well as electronic duplication of this guide, complete or in part, requires the written consent of ESERA-
Automation or E-Service GmbH. Errors and technical modification subject to change.
©
ESERA-Automation, E-Service GmbH 2019
www.esera.de
Programming Manual Controller-Gateway-Station V1.0 R1.1
Page 12 of 77
5.2.
Interface configuration Modbus TCP
Settings for the Modbus TCP interface are set via the Network Config-Tool. In the standard system the interface
is set to port 5000. If you want to use port 502 for Modbus TCP, change the port for the Ethernet interface in the
Network Config-Tool, Figure 4.2.1.
At the same time, you must also adapt the port for Config-Tool 3 (Figure 4.2.2) to these new settings.
4.2.1 Network Config Tool interface settings
4
.2.2 Config Tool 3, Config Tool 3 settings
IP address and port for
Ethernet interface for
Modbus data transmission
and configuration
Transfer IP address and port
from the settings of the
Ethernet interface