14
SPDIF_EXT *WT2496’s number (1,2) I ndicates signal (1) a nd ground (2).
SB Live Value WT2496
Front ch out. S/B_DIN
1 ----------------------------------------------------1
2 ----------------------------------------------------2
or
Rear ch out S/B_DIN
12 -------------------------------------------------- 1
10 -------------------------------------------------- 2
*using the front channel is recommended.
Digital In S/B_DOUT
6 --------------------------------------------------- 1
5 ---------------------------2
6. CD-ROM Digital Audio Input
If your CD-ROM is equipped with a 2-pin digital audio output (usually named “D” for signal
and “G” for ground), you can bypass all DAC circuitry of the CD-ROM and import the CD
digital audio signal directly to the WT2496 via this connector. To use the CD-ROM’s digital
audio as your digital input source, select
CD-ROM
as the
Digital Input
selection on the
WT2496 Control Panel.
When you connect CD-ROM to monitor an audio CD through the Waveterminal 2496,
make sure to match the signal pin to the corresponding signal pin. For example, the left pin
of the 2-pin header connector is a signal pin, so connect it to the letter “D” from the CD-ROM
digital output port. Some CD-ROM models simply do not support the digital out port for
CD audio. If you cannot hear any sound from the CD-Rom after making the proper settings,
you may need to ask to the CD-ROM manufacturer if the Digital Output port is in fact
activated.
