12
Kongsberg C-series
For best performance and minimum wear, do not let the bit stick out more than necessary.
Never use higher RPM than recommended by the bit
supplier.
Special care should be taken when using bits with
cutting diameter
larger than
shank diameter
.
Bits with small
cutting diameter
(3-4 mm; 0.12-0.16
in) are more balanced than bits with larger
cutting
diameter
Thus, they can run with higher RPM, normally 60.000.
Use large diameter bits (5-6 mm; 0.20-0,24 in) when
needed only.
Typical use is to get rid of the chips in thick materials.
Max RPM (HPMU) 60.000
Router Bit Edges
are brittle.
Never let bits touch each other, or other hard surfaces.
Always store in proper container.
106
