19
Kongsberg C-series
4.
The Carriage Beam continues to move slowly down until the lower plunger sensor on the plenum
detects the board on the table.
5.
The Carriage Beam continues to move downward to the “Pick Sheet Additional Travel” distance.
The additional travel is used to insure all of the pickup plenums get fully down onto the cut board.
6.
The Carriage Beam dwells for the “Delay to Build Vacuum Time” which allows vacuum to build at
the plenums contacting the board to be lifted.
7.
Once the “Delay to Build Vacuum Time” elapses, the carriage moves fully upward with the cut
board.
8.
When the carriage is in the full up position, the horizontal gantry moves the board over the pallet
stack.
9.
The carriage lowers the cut board to the stack and stops when the upper plunger sensor detects
the stack.
10.
The cut board is released to the pallet stack and the carriage returns to the full up position.
11.
The gantry then moves forward to the Park Position and waits for the next Pick command from the
cutter.
19.10. Touch Screen Display for Stacker Operation
The Touch Screen display is used to interface to both the feeder and the stacker and allows
access to useful machine functions and system parameters for both the Feeder and the
Stacker.
On any screen, the green circle with a question mark symbol indicates there is an informational
screen available. The informational screens contain helpful explanations related to the
functions on the screen (in English).
Pressing the green arrow buttons will advance through the available screens. Pressing the right
arrow button on each screen will eventually loop you back to the Main screen.
19.10.1. Stacker Main Screen
10.1.1 - Main Screen Message Window
247
