19
Kongsberg C-series
To start up the system; set the Main
Disconnect of both the feeder and stacker to
the ON position, and then press the lighted
Power ON pushbutton located on the door of
the feeder electrical enclosure.
Once pressed, the white lighted pushbutton
will be turned on, indicating that control
power has been applied to the system.
The control system requires a short period of
time to initialize. The system is initialized and
when the blue Fault Reset pushbutton begins
flashing on the control console.
Once the controller is running, press the Fault Reset pushbutton to reset the safety circuit.
The safety circuit will reset provided there are no active machine faults.
Homing the Feeder
The feeder must be Homed before it will
operate in Auto mode.
1.
Set the Mode selector switch to Auto.
2.
Press the Home button on the Main
Screen.
The carriage beam will move up to the
carriage home position and the gantry will
move back to the gantry home position.
The rectangular bar will turn green when
the homing process is completed.
Feeder Find Stack Height
Press the Find Stack button on the Main
Screen.
The carriage will move slowly down until the
suction cup with the plunger sensor detects
the top of the board stack.
The height of the stack is recorded by the
control system and the carriage beam returns
to the Home position,
The feeder is now ready for automatic
operation with the cutter.
250
