12
Kongsberg C-series
How to replace a Knife Blade
• Loosen the two screws holding the blade
clamp.
• Pull out the old
Knife Blade
.
• Insert the new blade.
• Ensure the blade align exactly with the
alignment pins.
• Fix the blade clamp.
At left, the clamp is removed just to show how
to align the
Knife Blade
.
After a blade change, the tool depth should be checked again.
How to set the cutting depth of the Bevel Knife
The default cutting depth for
Bevel Knife
is cut through the entire material.
Define the depth of the bevel cut in the
Layer Setup
.
Normally, the cut should extend down to just above the bottom liner.
About tool adjustment
For the
Bevel Knife
, we recommend the manual procedures for tool rotation and centre offset
adjustment.
Use a thin
Folding Carton
material when adjusting tool rotation and centre offset.
Remember that you should look at the bottom side of the material for correct alignment.
The adjustments depend upon the actual material due to weight, structure and thickness.
For optimal result, a fine tuning of the adjustments in the actual material should be carried
out.
For more information about how to run the
Adjustment Wizards
, see the
Tool Configuration
chapter
92
