11
Kongsberg XL
9.
Press
Tool Override Down
once more to lower the
Tool
again.
10.
Note how the knife enters into the material.
11.
Press
Tool Override Down
once more to lift the
Tool
again.
12.
If knife enters exact into the cut, the angle is correct; select
Finish
to exit.
13.
If seen in the cutting direction, the knife enters to the left of the cut, the
Angular Offset
Value
should be decreased. Repeat from point 5.
14.
If seen in the cutting direction, the knife enters to the right of the cut, the
Angular Offset
Value
should be increased. Repeat from point 5.
11.6. Center Offset Adjustment
The adjustment can be done using the
Adjustment Wizards
, or by a
Manual Adjustment
procedure:
Adjustment using Wizards
1.
Put an appropriate test material, that means a thin paper on the table (any significant
material thickness will create a misleading offset in this wizard).
2.
Switch vacuum on.
3.
Select the
Tool
to be adjusted.
4.
Press the
Adjust Active tool
button to enter the wizard selection dialog.
5.
Select
Center Offset Adjustment
.
6.
Follow the instructions given by the wizard, step by step.
7.
Repeat the procedure for all
Tools
mounted.
Manual Adjustment
1.
Place an appropriate test material on the table, and switch
Vacuum On
.
2.
From
Tool Configuration
dialog, select one
Tool
.
3.
Press
Adjust Active Tool
to enter the
Wizard Selection Dialog
.
4.
Select
Manual Adjustment of Center Offset and Angle
.
5.
Enter value for the
Center Offset
and select
Activate
.
6.
Note that the
Tool
will move as the new value is activated.
7.
Press
Tool Override Down
, and
Jog
approximate 10 cm to make a test cut.
8.
Press
Tool Override Down
once more to lift the
Tool
.
59
