13
Kongsberg XN / iPC 2.0
116
Parameter
Description
Tool Offset
Adjust offset relative to laser pointer.
For more information about how to run the adjustment wizards, see
Tool Configuration
.
13.2
Bevel Knife
Bevel Knife
is a special-purpose tool
for 45 degree angled cuts.
Lag = 3.5 mm / 0.14 in.
How to replace a Knife Blade
• Loosen the two screws holding the blade
clamp.
• Pull out the old
Knife Blade
.
• Insert the new blade.
• Ensure the blade align exactly with the
alignment pins.
• Fix the blade clamp.
At left, the clamp is removed just to show how
to align the
Knife Blade
.
After a blade change, the tool depth should be checked again.
How to set the cutting depth of the Bevel Knife
The default cutting depth for
Bevel Knife
is cut through the entire material.
Define the depth of the bevel cut in the
Layer Setup
.
Normally, the cut should extend down to just above the bottom liner.
