background image

Note: The light should now be dark during daylight. The solar module also 

has a twilight sensor function. If the solar module is in darkness, then the 

voltage of the solar module drops and the light will switch on automatically. 

8.  The solar module can be placed on the ground using the ground spike. 

The position of the spherical joint can be adjusted for best alignment 

towards the sun.

Note: Illumination time is highly dependent on the intensity and duration 

of sunlight (solar irradiation) during the day. Illumination time is generally 

expected to be less during the winter months. Should the light not switch 

on on the first evening, please wait for a sunny day.

5. Colour setting

The light has 2 different colour settings. These are selected using the 

button underneath the light (Centre). Press the button to select the option 

you want. 

1. Light color changes every minute

The light color changes every minute slowly between every color.

2. Fix the lighting color

When you want to fix the lighting color to permanent light, please press 

the switch on the bottom of the light. To start color changing please push 

the switch again. 

6. Replacing the battery pack

As a rule, the battery pack must be replaced every 2 years with a new 

one of the same size and type. It is a 3.2V/ 400mAh or 3.2V/ 1500mAh 

lithium-Fe battery. Replacement batteries are obtainable from your dealer 

or the manufacturer (www.esotec.de).
The following is the correct procedure for replacing the battery:

1.  Loosen the connections at the bottom of the lamp. 
2.  Rotate the bottom of the globe counter-clockwise.
3.  Disconnect the connector of the battery from the connector on the cable 

of the board.

Note: To do this, press the latch down to release the plug connection.
4.  Replace the battery with a new, identical battery. 
5.  Close the lamp in the reverse order used to open it, and remember to 

reconnect the solar module cable. 

Note: Used batteries, whether rechargeable or not, must be disposed of 

in an environmentally friendly manner and should not be disposed of in 

domestic rubbish bins. Your dealer is obliged by law to accept old batteries 

for disposal.

7. Troubleshooting

Lamp does not switch on at nightfall.

-   An ambient light source (e.g. street light) simulates natural light in the 

solar module and prevents the light from switching on automatically. 

Place the solar module in a darker place. 

Lamp does not switch on at nightfall, or switches on only briefly. 

-   Check the connector plugs on the solar module cable and battery are 

properly connected.

-   Battery is weak or faulty. Replace the battery at least once every 2 

years.

8. Technical data

Solarpanel:

Solar panel: 

2 Wp crystalline

Nominal voltage: 

5.76 V

Nominal current:  

347 mA

IP Rating:  

IP 65

Temperature range:  

-30°C to +70°C

Ball Light:

Lamps: LEDs

Luminescent white:  

4500 K 

Light material: 

PE

IP Rating:  

IP 65

Protection class:  

III

Temperature range:  

-10°C to +40°C

Charge time until fully charged:  

Approx. 6 hours in full sunshine

Illumination time when fully charged:   Up to 20 hours

Battery pack (Li-Fe) (since 2017 new version) 

30 cm ball light:  

3.2 V / 400 mAh, spare part No.: 901025

40 and 50 cm ball light:   3.2 V / 1500 mAh, spare part No.: 901026

 

Copyright esotec GmbH

button

Reviews: