14
Turning the power off
There might be noise from the speakers if the power is turned off sud-
denly. When you turn the unit off, follow the steps below.
1
If a connected device is playing back, stop playback.
0
Turn off the power amplifier first.
2
Turn the unit's VOLUME knob counterclockwise to
minimize the volume.
V
Always turn the volume to the minimum level before
you turn the unit on or off. Failure to do so could
cause sudden loud noises that might result in harm
to your hearing or damage to the speakers when
you turn the unit on.
3
Press the POWER button to turn the unit off.
4
Turn off the power of the connected input source
devices.
Using the dimmer
Each time you press the DIMMER button, the brightness of the display
and indicators change as follows.
3
(Standard brightness)
2
1
0
(Unlit)
0
Even when set to 0 (unlit), the display will light at standard bright-
ness for a few seconds when you press a button or turn a knob.
0
In setting mode, the display lights at standard brightness.
Muting the output
Press the remote control MUTING button to temporarily mute the
sound. Press again to restore the previous volume setting.
0
While the sound is muted, “MUTE” and the selected input connec-
tor name appear alternately on the display.
0
You can also restore the sound by turning the VOLUME knob or by
pressing the VOLUME buttons (+/−).
Basic operation (2)
Summary of Contents for C-02X
