26
of 34
V 1.0
www.esavep.com
Changing Parameters
Careful consideration should be given before changing any of the parameters set by
your installer, and advice taken from the ESP Technical Team if necessary. Indeed,
changing some of the parameters may be contrary to current legislation. Should you
wish to change any parameter, the following guidance should be followed:
Firstly, from the top-level menu, use the up and down keys
to highlight "
Parameter"
the press the enter key to display
the screen shown in figure 7.
Operation
Highlight “operation” in the parameters menu then press the
enter key to display the screen shown in figure 8.
Use the up and down keys to highlight the parameter you
wish to change, press the enter key to select it, then the up
or down keys to alter the setting. Once your change has
been made, press the Escape key to save the setting and the
Escape Key again to return to the Parameter menu. Please
note that the adjustable range for the “Out Water”
temperature is 10°C to 60°C. The recommended value is
55°C. The “ΔT (heating) adjustable range is 2°C to 60°C.
The default value is 5°C.
Auxiliary Heating
Highlight “Aux heating” in the parameters menu then press
the enter key to display the screen shown in figure 9.
Press the up or down keys to highlight the parameter you
wish to change. Press the enter key to select then the up and
down keys to change the parameter value. Once the new
value has been selected, press the escape key to save the
setting then press it again to return to the Parameter screen.
The “Start temp” adjustable range is 30 °C to 90°C and the
“Start Delay” adjustable range is 0 to 90 Mins ( in 5min
intervals). The recommended settings are 55°C and 40 mins.
