D2SENSE KEEPER 100
Alarming Function
The warning LEDs indicate that pedestrian(s) have been
recognized within the danger zone
Get into visual contact
immediately!
The
Danger Zone 2
LEDs
flash yellow if
pedestrians
equipped
with
BEEPER
are
recognized
within
medium range
to the
KEEPER device.
The
Danger Zone 1
LEDs
flash
red
if
pedestrians
equipped
with
BEEPER
are
recognized
within short
range
to the KEEPER. An
additional
warning
sound occurs.
Battery Charging
Step 1: Lift the protection cap
and move it to the left or to
the bottom.
Top Site
Step 2: Connect the micro
USB charging cable to the
BEEPER receptacle.
During charging the Charge
Level LED flashes red/green if
the KEEPER is active or
continuously
red
if
the
KEEPER is off. The LED
flashes continuously green
when the charging procedure
is completed.
Installation of the KEEPER
The KEEPER should be installed as high as possible within the
driver‘s cabin to achieve a good radio coverage. One or two
external antennas might be also required at the outside of the
machine. The visual field of the driver must not be impaired!
The KEEPER may be installed by using the included holder.
Please notice the safety instructions and the system verification
procedure as published in the user manual.
St
an
d
0
1
/2
0
1
4
Segment Display
Attention:
The driving paths must be
checked
at
all
times
independent of the alarming
function!
The segment display indicates
how many people equipped
with
BEEPER
have
been
recognized within the red
Danger Zone 1
.
Persons within the yellow
Danger Zone 2
are not
considered.
See over
