All the materials mentioned below are not included with the swing.
Materials needed:
- 1 each 600 x 50 x 100 mm timber (24 x 2 x 4 inches)
- 2 each 200 x 50 x 100 mm timber (24 x 2 x 4 inches)
- 1 each eye bolt
- nails 4x ø6x100mm
- screws 6x ø3x100mm
1. Drill 15 mm (0.6 inch) diameter hole 40 to 50 mm (1.6 to 2 inches) from each end of the 600 x 50 x 100
mm (24 x 2 x 4 inches) timber.
2. Nail 200 x 50 x 100 mm (8 x 2 x 4 inches) to each side of swing set beam.
3. Centre 600 x 50 x100 mm (24 x 2 x 4 inches) perpendicular across top of beam and 200 x 50 x 100 mm
(8 x 2 x 4 inches).
600 mm
200 mm-x-50-x-100
600mm x 50 x 100
200 mm-x-50-x-100
Oogbout
EYE BOLT
600 mm (24 inch)
200 x 50 x 100 mm
(8 x 2 x 4 inches)
200 x 50 x 100 mm
(8 x 2 x 4 inches)
600 x 50 x 100 mm
(24 x 2 x 4 inches)
EYE BOLT
600 mm (24 inch)
200 x 50 x 100 mm
(8 x 2 x 4 inches)
200 x 50 x 100 mm
(8 x 2 x 4 inches)
600 x 50 x 100 mm
(24 x 2 x 4 inches)
Eye bolt with wood screw threading
Minimum size requirements:
Min. 32mm (1.25”)
Min. 12mm (0.5”)
Min. 12 mm (0.5”)
U bolt
