PROGRAMMINGS
Pagina
105
L.C.R.
The LCR (Least Cost Routing) service allows you to route the outgoing calls
over one line or other according to the dialled number, for cost optimization
purposes.
LCR settings are based on service classes, which have to be previously
programmed.
Each service class must be associated with lines compatible to filter sequence
and, if needed, with a provider present over the line. Hi-Pro will automatically
dial the provider code during outgoing calls.
Association to lines is done according to the Lines Engagement Table (see
“Lines Engagement Table ”).
Note: in order for different extensions to use the LCR system, the
service must be enabled via the “Service activation”
programming in the “Extension programming" chapter.
Note: the manual engagement of the line, or the selection via the
“line” button of the ST 600 Personal Phone system telephone,
deactivates the LCR function.
E.g.: a GSM interface is connected to line L04, then we want the mobile
phone numbers to exit from this line .
As a default setting, the service class 05 contains the sequence “3”
(initial digit of mobile phone numbers), so the programming to perform is
to assign a Line Engage Mode having L04 as first line to the class 05
(i.e. mode 08 in Lines Engagement Table ).
Service classes
01 02 03 04
05
06 07 08
Prefix
-
Line Engage Mode
Mode 08
L04 L03 L02 L01
Assigning the lines to a service class
Allows you to associate a Line Engage Mode (compatible with the filter
sequence) to a service class.
(To check or modify the available modes in Lines Engagement Table see
paragraph “Lines Engagement Table ”)
