Pagina
16
HI-PRO 280
HI-PRO
280
INSTALLATION
The following connections must be provided:
•
connection to a 230 Vac power supply socket
•
connection to external telephone networks, if needed
•
connection of BCA (analogue standard) telephones
•
connection of ST 600 Personal Phone system telephones
•
connection of doorphone, if any
•
connection of actuator relays, if any
•
connection of digital inputs, if any.
Recommendations
- Do not install Hi-Pro near other electronic or magnetic devices, since they
could be affected by RF interferences coming from the device.
- Do not lay the telephone cables near the 230 Vac mains.
- We recommend connecting the telephones to Hi-Pro using a twisted pair
cable. Use multi-pair cables only when absolutely inevitable (and, in any case,
never more than 20 m long).
Operations to perform
Drill two 5 mm diameter holes on the wall, 6 cm apart and screw the
bracket.
Place Hi-Pro on the bracket and make it slide
Loosen the right lateral part of the lid and rotate it downwards.
Connecting the external lines
Connect, if present, the external lines to the analogue lines terminals
(see Terminals page
Errore. Il segnalibro non è definito.
).
Connecting internal telephones
Connecting ST 600 Personal Phone system telephones
Up to 8 system telephones can be connected to Hi-Pro .
ST 600 telephones allow knowing the status of the external lines and the
extensions, making the use easier. Moreover, they are interfaceable with the
PC.