Installation
16
Care@Home™ Pro System Installation Guide
At least 2 m (6 ft. 7 in.) high and at the correct angle to view activity in the desired coverage
area
Away from any heat source or air-conditioning vents
Away from any glaring light sources
Not opposite doorways or hallways
No overlap in sensor coverage areas
For the best practices for positioning peripherals by room, refer to 4 Best Practices on page 26.
For position considerations for a specific peripheral, refer to the user guide for that specific peripheral.
For an index of the user guides, refer to 5 Care@Home™ Documentation on page 29. You can access
the guides at:
http://www.essence-grp.com/resources/smart-care-download.html
3.2.
Installing the CP
To install the CP, you need the following:
SIM-card, allocated by your cellular service provider
Backup battery, provided in your kit
Power cable, provided in your kit
Follow the installation instructions, including the placement recommendations, listed in the
ESUGSC003 Care@Home
™
CP User Guide.
Figure 4 – Caption
Verify that the installation of the CP is successful as follows:
Check that the power LED is lit green and stable.
Check that the communications LED is lit green and stable.
Power LED
Communications LED
