Camera
Motion
Detector
15
Quick Setup Guide
Install the Siren (SRN)
Perform the following procedure to install the mounting base of the
Siren:
1.
Release the Siren mounting base by lifting the tab and sliding the
base in the tab’s direction.
2.
Peel the double-sided, adhesive tapes’ protective strips.
3.
Position the Siren so that the device is both accessible and not
easily found by intruders.
4.
Install the Siren mounting base on a flat, vertical surface that is
clean, dry, and smooth.
Install the Camera (IPD) and the Motion Detectors (PIR)
Perform the following procedure,to install the mounting base of the
IPD or PIR devices:
1.
Peel off the tape protective strips on the wall mounting base.
2.
Before installation, gently shake the device until you hear a
“rattling” sound.
3.
Position the device on a wall or in a corner of a room between 2
walls, approximately 220cm (7’2”) above the floor and at least
10cm (4”) below the ceilings, with the spherical lens pointing
downward, as shown in the images to the left.
Note:
Avoid device exposure to any direct light source.
5.2
5.1
Summary of Contents for WeR@Home
Page 1: ...Quick Setup Guide...