16
Quick Setup Guide
Install the Door/Window Sensor (MGL)
This sensor device consists of two (2) parts.
●
The Transmitter
- Position on the fixed frame of the door or window
●
The Magnet
- Position on the moving edge of the door or window
Perform the following procedure to install the mounting base of the Door/Window
Sensor:
1.
Release the Transmitter base by inserting a coin into one of the edge slots and
twist it to open the cover.
2.
Peel the tapes’ protective strips for both units.
3.
Attach the base of each unit to its designated location, while aligning marks on
both components, and apply pressure.
4.
Re-insert the Transmitter into the base.
5.4
Assigning Device Names
All devices in the WeR@Home™ Kit are assigned default names, except for the
Remote Control. The Remote Control is assigned a device name when the Remote
Control is registered with the WeR@Home™ System.
If you want to change the name of a device in the WeR@Home™ System, perform
the following general procedure:
1.
Log in to the WeR@Home™ Web Application.
2.
Click the
tab to access the Devices module.
3.
Select the device for which you want to change the device name.
4.
Enter the purpose and the location of the device as the name of the device and
click the
button.
Note:
●
Ensure the two components are not more than 2 cm (.75 inches)
apart.
●
Ensure both components are mounted high and out of reach.
5.3
Summary of Contents for WeR@Home
Page 1: ...Quick Setup Guide...