Essential Garden 640-08477458-7, Use And Care Manual

 15

OPERATING INSTRUCTIONS                                                                                                       

                                                                                                                                                            Fig. 13 

Checking for Leaks   
 
Your patio heater has been checked at all factory connections for leakage. To check the 
connection at the gas hose/regulator/cylinder: 
 
a. Make leakage solution by mixing 1 part liquid dish soap and 3 part water. 
b. Spoon or brush several drops (or use squirt bottle) of the solution onto the gas 

hose/regulator and regulator/cylinder and hose connection. 

c. Turn on gas cylinder valve. Inspect the connections and look for bubbles. 

1. If no bubbles appear, the connection is safe. 

2. If bubbles appear, there is leakage. Loosen and re-tighten this connection. If it still 

leaks, please call customer service at: 1-855-CHANT-US (1-855-242-6887). 

Lighting Instructions   
 
1. Turn the LP gas tank valve OFF. Push the control 

knob in, turn OFF, and wait 5 minutes for any 
gas to clear. 

2. Turn the tank valve ON. Push control knob in 

and rotate to PUSH. And, push the igniter button 
until the burner is ignited. If igniting the burner 
for 5 seconds continuously but the burner fails to 
remain lit or becomes extinguished, repeat step 
2 after 5 minutes. Complete shutoff period 
before relighting. 

3. Once the burner has lit, continue to hold the 

control knob in for 30 seconds, and then 
release. 

4. Turn the control knob from HIGH to LOW to the 

desired heat setting. 

 
 
 
 
For complete shutdown 
1.

Please turn the knob to “PUSH” position first, then 
push and turn to “Off” position for complete shut 
off. 

2.

Turn the LP gas tank valve OFF before remove the 
LP gas tank. 

PUSH/HIGH

OFF

LOW

push

Igniter